I have not but i have an easier way as long as your map doesnt go beyond 50%
1)You need a pc6 Zero map. You will have to request one from dynojet.
2)copy the pc5 map
3) paste it onto the ‘autotune trim’ section of the pc6 zero map.
4) send to device
5) check and make sure the map was sent to the pc6 unchanged
**note: IT IS VERY IMPORTANT TO USE A ZERO MAP WHEN DOING THIS. THERE IS A BASE TUNE THAT YOU CANNOT SEE ON ALL OTHER PC6 maps. The loophole here is that the autotune map allows for 50% adjustability compared to the 15% the fuel adjust map allows for. You do NOT need to enable autotune. You should not need to make any adjustments beyond 50% unless you have a forced air setup or some kind of serious motor work. ***